Application Sheets

These application sheets should be considered as a starting point and they should
be adjusted by the Distributor according to the conditions of each territory.

IMPORTANT: All the equipment and its components which will be in contact with Quick-Sol® during the application must be freed of any residues from other products used in prior applications. (Should you have any doubts please contact us).

In the event that the equipment to be used for the application of Quick-Sol® is fitted with a filtering system, it is highly recommended to rinse the equipment of all residues; following the instructions below for proper rinsing.

Rinsing Instructions:

• Dilute the required amount of Quick-Sol® for the current application, following the dilution specifications of the distributor plus an extra quantity to cover two more acres. The additional quantity will be the amount needed to rinse the equipment or Rinsing Quantity.
• Move the equipment to an area suitable for chemical rinsing.
• Turn on the pump until product begins to flow through the nozzles. Stop the pump and wait ten minutes.
• Turn on the pump again until 20% of the Rinsing Quantity has passed through the nozzles. Turn off the pump and wait five minutes.
• Run the additional 80% of the Rinsing Quantity through the system and stop the pump.

Once the equipment has been properly rinsed, it can be moved to the area where the product is to be applied and begin application.

If you need to clean the tank, mixing containers, etc, please click here!